1. Select a position for your Pool Shower away from powerlines & power points.

2. Run plumbing underground using ½” poly or copper tube, bring plumbing pipe or pipes out of the ground approximately 4” (100mm) in the centre of the position of the shower.
(The shower has a 295mm round base) If using a Hot & Cold Water shower the Hot water should be tempered to max.55 deg (Council Regulations) the showers do not have a tempering device.

3. Concrete or pave a level area approximately 400mm or bigger for the shower to be secured to.
(Note: Pavers should be bedded in cement to add weight and stability)
Pipes should have lagging or protection from concrete (some plumbers use a short piece 90mm stormwater pipe to protect the pipes. Flush pipes to clean.

4. Cut the pipes to the desired length staggering the Hot & Cold pipes to make it easier to connect to flexi-connectors. Using compression fittings (1/2” C x MI Union) for copper or Tita fittings (1/2”P x MI Connector) for poly connect pipe work to the ½” FI Flexi-connectors hanging out of the base of the shower.
Note: Hot & Cold are marked with Red Tape (Hot) and Blue Tape (Cold)
Red is on the right hand side of shower when positioned in using position.

5. When tightening to flexi-connectors no thread tape is required. Hand tighten then nip (½ turn) with spanner. Hoses will push inside shower when in upright position. Turn shower on to check for leaks!

6. Position shower in your preferred direction, mark & drill holes using a 10mm Masonry drill (12mm Drill for Beach Showers). Tap dynabolts supplied in with a hammer gently and tighten with spanner. To take out looseness or unevenness in shower, use silicone between shower and concrete or paving.

7. Clean your new Pool Shower with the enclosed Hillmark Steelkleen stainless steel wipe.
The wipes are designed to remove finger prints and water marks, and prevent brown staining. Should light scratching occur, use a Scotch Brite green pot scourer and rub up & down the shower, in the direction of the grain (not across the grain). Please be aware we use structural stainless steel and sometimes there are flaws or scratches in the tube. We do our best to try to remove these before manufacture.

8. For easy maintenance of your Pool Shower, wipe over regularly with Hillmark Steelkleen spray (purchased through most supermarkets). We use 316 Stainless Steel which doesn’t rust. If a brown staining occurs use a Scotch Brite and liquid dishwashing detergent as per instruction no.7. then rinse with clean water The Tapware used on the shower is plated brass & pitting may occur in high salt or dusty areas. (Do not use Scotch Brite on tapware as scratching will occur.) Regular cleaning helps prevent pitting & staining and we suggest Hillmark Steelkleen spray also.

9. Thankyou for purchasing a Rainware Pool Shower. Your shower is now ready to use.


Warning: If the shower is in direct sunlight this could cause the water held in the shower or garden hose connecting the shower to heat up and cause scalding. Please ensure before using the shower to let water run for a few moments to washout any overheated water.

Rainware: Phone 07 54929357
Mobile 0411660933
Fax 07 54929619
Email rainware@bigpond.com