|
1. Turn off mains water supply.
Download Instructions
2. Turn on garden tap to drain excess water and
remove garden tap off outlet (if applicable).
3. Clean thread on outlet of old thread tape etc.
4. Refer enclosed picture for pool shower layout.
5. Fit wall disc, thread tape and new Pool shower
tap.
6. Slide on stand off clip up from bottom of pool
shower pipe (Straight end).
7. Slide on gland nut and then nylon olive to bottom
of pipe.
8. Fit bottom of pipe to tap and secure loosely
with gland nut.
9. Bottom of pipe can be shortened if needed (Pipe
outlet / Shower rose approx 2 metres from ground)
10. Mark holes on wall for screws using standoff
clip as template to secure Pipe with stand off clip approx ¾
of the way up the pipe.
11. For brick walls drill 2 x 6mm holes in wall
and fit supplied plugs and screw up stand off clip with supplied
screws.
12. Tighten bottom gland nut and nylon olive to
tap.
13. Fit shower rose to pipe using thread tape wipe
shower with steelkleen wipe provided.
14. Turn on water mains supply and check for leaks.
15. Your new Pool Shower is now ready for you to
use.
Warning: if Pool Shower is in direct sunlight this could cause the
water held in pipe to heat up and cause scalding. Please ensure
that before using shower to let water run for a few moments to washout
any overheated water. |
