|
1. Select a position for your Pool Shower away from powerlines &
power points.
2. (A) Dig a hole approximately 250mm in diameter and 600mm
deep.
(A&B) Run plumbing underground using ½” poly or
copper tube.
If using a Hot & Cold Water shower the Hot water should be tempered
to max.55 deg (Council Regulations) the showers do not have a tempering
device.
3. (A&B). Flush pipe work.
4. (A&B) . Cut the pipes to the desired length.
Using compression fittings (1/2” C x MI Union) for copper
or Tita fittings (1/2”P x MI Connector) for poly connect pipe
work to the (A) ½” FI Sockets or (B) ½”
Flexi connectors protruding out of the shower. Note: Hot & Cold
are marked with Red Tape (Hot) and Blue Tape (Cold)
5. Turn shower on to check for leaks!
(A) Fill hole with cement and position shower to the desired direction.
(B) Mark and drill holes to mount shower on wall {10mm for cement
or brick walls} & {4.5mm for timber walls}
Fix shower to wall using screws & plastic plugs provided
6. Thankyou for purchasing a Rainware Pool Shower. Your shower is
now ready to use.
Warning: If the shower is in direct
sunlight this could cause the water held in the shower or garden
hose connecting the shower to heat up and cause scalding. Please
ensure before using the shower to let water run for a few moments
to washout any overheated water.
Rainware: Phone 07 54929357
Mobile 0411660933
Fax 07 54929619
Email rainware@bigpond.com
|
